Water heater flush and anode rod service in Hayward, CA

A flush clears the sediment that settles in the bottom of a tank water heater. The anode rod is the part inside the tank that corrodes so the tank does not. Friendly Services flushes tanks and checks and replaces anode rods in Hayward and across the Bay Area as part of our water heater maintenance. Call (510) 626-9773.

Start here, or go straight to water heater maintenance.

What is sediment?

Minerals in the water settle out when it is heated and collect on the bottom of the tank, between the burner and the water. The layer traps water under it, which boils and pops. It also insulates the water from the burner, so the heater runs longer to make less hot water, and the bottom of the tank takes more heat than it should.

What is the anode rod for?

It is a metal rod that hangs inside the tank and corrodes in place of the tank. As long as there is metal left on it, the steel tank is protected. When the rod is used up, the tank itself starts to rust, and a rusted tank cannot be repaired. A rod replaced in time protects the tank.

Signs your tank needs service

  • Popping, rumbling or banging from the tank while it heats.
  • Rusty or smelly hot water. If only the hot water is affected, the tank or rod is the likely source. If the cold is rusty too, look at the pipes; see galvanized pipe replacement.
  • Less hot water than there used to be, or water that takes longer to heat.
  • It has never been flushed and the rod has never been checked.

What our visit covers

  • We flush the sediment from the tank.
  • We check the anode rod and replace it if it is spent.
  • We test the temperature and pressure relief valve.
  • We check the burner, the pilot or igniter, and the vent.
  • We check the gas and water connections and the shutoff valve.
  • We check the earthquake straps and the expansion tank.
  • We tell you what we found and how much life the tank has left.

When is a flush not the right call?

We look at the tank first. On an old tank with heavy sediment, or one that already shows rust or a leak, a flush will not bring it back, and we will say so. Sometimes the money is better saved for a new heater. See repair or replace and water heater repair and replacement.

How often?

Once a year is the usual maker advice, and more often with hard water. Have a tankless unit? It needs tankless descaling instead.

Who is Friendly Services?

Licensed plumbers with over 20 years in Hayward. CSLB #1156315. Our own work carries a five-year workmanship warranty, and estimates are free. We are based in Hayward and work across the Bay Area, out to Sacramento.

Book it with the rest of your water heater maintenance.

Friendly Services home · All plumbing services

Service area

We are based in Hayward and serve these East Bay cities. Pick your city for local plumbing information.

Frequently asked questions

How often should a water heater be flushed?

Once a year is the usual maker advice, and more often with hard water.

Why is my water heater popping or rumbling?

Sediment on the bottom of the tank traps water under it, which boils and pops. A flush may help; on an old tank it can mean the end is near.

What does an anode rod do?

It corrodes in place of the tank. When it is used up, the tank starts to rust.

Why is my hot water rusty?

If only the hot water is rusty, the tank or anode rod is the likely cause. If the cold is rusty too, the pipes are. We check which.

Can you flush an old water heater?

We look at it first. On an old tank with heavy sediment, a new heater is sometimes the better use of the money.

Do you service all brands?

We service the common brands, including Bradford White, Rheem and A.O. Smith.

Call (510) 626-9773

More plumbing answers

Licensed Insured Bonded 5-Year Warranty CSLB #1156315