What affects repipe cost?

What a whole-house repipe involves depends on how many fixtures your home has, how the water lines are routed, whether the house sits on a crawl space or a concrete slab, and whether you choose copper or PEX. Because two houses of the same square footage can have very different plumbing layouts, our licensed plumbers inspect your home first and give you a written scope before any work starts. Call Friendly Services in Hayward at (510) 626-9773.

How do bathroom and fixture counts change the job?

A whole-house repipe replaces the hot and cold supply lines to every water-using fixture. Our plumber counts each sink, toilet, tub, shower, washing machine box, dishwasher connection, refrigerator ice line, water heater tie-in, and outdoor hose bib. How close those rooms sit to one another matters too: two bathrooms sharing a single wet wall take less pipe and fewer wall openings than bathrooms at opposite ends of the house.

How does foundation and routing affect a repipe?

  • Raised foundation with a crawl space. Many older homes in Hayward, San Leandro, and Oakland sit over a crawl space. Running main lines underneath the floor and stubbing up into each bathroom is usually the most direct route.
  • Concrete slab foundation. When old copper leaks under a slab—common in Fremont and later Hayward tracts—we often avoid breaking the floor by shutting off the slab lines and routing new pipes overhead through the attic and down inside the walls. See slab leak repair.
  • One story vs. two stories. A two-story home requires vertical risers between floors and careful planning around joists and finished ceilings.

How does pipe material—copper vs. PEX—make a difference?

We install both rigid copper and flexible cross-linked polyethylene (PEX). As explained on our copper vs. PEX repipe page, PEX comes in long rolls that bend around framing with far fewer fittings and smaller wall openings, which reduces both material and installation time in a finished house. Copper is rigid metal that needs soldered or pressed fittings at every turn, and it is a common choice where piping is exposed, such as outdoors or at the water heater. We can write your scope for either material or both so you can compare them directly.

What else is part of a complete repipe scope?

  • Sound existing pipe. If a newer bathroom remodel already has modern pipe in good condition, we check whether it can stay connected rather than being replaced twice.
  • Shutoff valves and pressure regulator. We can include new fixture shutoff valves and supply lines in the scope, and we check the main shutoff valve and water pressure entering the house.
  • Main water service line. The repipe covers the house piping; if the buried line from the street meter to the house also needs work, see water line repair.
  • Permits and inspections. We pull permits when the job needs one and test the new system under pressure.

How do you get a written scope for your home?

If you are noticing signs you need a repipe, our licensed plumber walks the property with you, checks the accessible pipe and water pressure, and writes out everything the job includes. Friendly Services is located at 773 W A Street, Hayward, CA 94541, with CSLB license #1156315 and over 20 years in Hayward. We answer 24/7. Call (510) 626-9773 or book an appointment.

Whole-house repiping · Copper vs PEX · Signs you need a repipe · All plumbing services

Service area

We are based in Hayward and serve these East Bay cities. Pick your city for local plumbing information.

Frequently asked questions

What is the biggest factor in repiping a house?

The number of plumbing fixtures and how the new water lines must be routed through the building—whether from an open crawl space, through an attic over a slab, or across multiple stories.

Does choosing copper or PEX change the scope of a repipe?

Yes. PEX is flexible and bends through walls with fewer fittings and fewer access openings, while copper is rigid metal that requires fittings at every turn. We can write an estimate for either material.

Why does a slab home repipe differ from a crawl-space home?

In a crawl-space home, most pipe runs underneath the floor. In a slab home, the old lines under the concrete are shut off and new lines are routed overhead through the attic and down inside the walls.

Do you pull a permit when repiping a home?

Yes. We pull permits when the job needs one.

How do I get a written repipe estimate for my home?

Call (510) 626-9773 to schedule an on-site visit. We answer 24/7.

Call (510) 626-9773 Book appointment

More plumbing answers

Licensed Insured Bonded CSLB #1156315